Keg Dispensing Supplies

Lock that shank on tight! A lock nut for a beer shank comes standard with most shanks. It goes on the backside of the front flange and tightens against the wall of the kegerator surface to create a sturdy connection. A must have if your shank has no existing lock nut!

This CO2 shutoff with 1/4" MPT threading and check valve is ideal for use with CO2 regulators and manifolds! It has 1/4" MPT right-hand threading on one side that threads into most standard regulators and manifolds. On the other end is standard 1/4" MFL threading, which works perfectly with standard swivel nut sets and other 1/4" MFL fittings. If using a swivel nut set, we recommend using a plastic flare fitting as well, in order to create a good seal. Get one of these to replace a damaged or missing shutoff, put on a wye splittler, or create your own CO2 apparatus!

This product is designed to cool a beer tower on a direct draw type draft beer system. The number one complaint about any direct draw kegerator is that the beer faucet & shank get warm and your first 1/2 glass of beer is always foamy. But the solution is less than 5 minutes away - just install this tower cooler. It works by continuously blowing a small volume of cold air into your beer tower and the cold air keeps your beer shanks and faucets ice cold. A side benefit is that the continuous cold keeps faucet mold and bacteria growth at an absolute minimum. Installs in minutes with no tools!